Xoutpost.com - Transfer case

Page 2 of 10

Show 200 post(s) from this thread on one page

Xoutpost.com (https://xoutpost.com/forums.php)

- X5 (E53) Forum (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/)

- - Transfer case (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/74441-transfer-case.html)

Triple X5

07-23-2010 01:53 PM

As far as the warning goes I just remember something when put it in gear I remember hearing a cling sound didn't think anything of it but now it make sense the spline had a little play in it so all it took was time

Sent from my iPhone using Tapatalk

admranger

07-25-2010 11:56 AM

Glad you are back on the road again.

CharlieHustleX5

07-25-2010 02:17 PM

Had you ever changed out your transfer case fluid?

Triple X5

07-25-2010 03:40 PM

No I haven't but I'm getting a full fluid over-haul

Sent from my iPhone using Tapatalk

nikpottala

07-27-2010 10:22 AM

I just had the same thing happen to me and I found this thread and sent my drive shaft to racemailibu572 and he put a longer spline on the end. He provided very quick turn around.

http://www.xoutpost.com/bmw-sav-foru...ft-flawed.html

I didn't have to replace or rebuild my transfer case so I ended up with a solution for less than $800 including the towing and repair by my local AMMCO garage.

Triple X5

07-27-2010 12:21 PM

Thanks gonna call

Sent from my iPhone using Tapatalk

tho656

07-27-2010 07:07 PM

glad to hear its on its way back on the road

racemalibu572

07-27-2010 07:41 PM

Triple x5, did you already have the output coupler replaced on your case and did you already call me today about a repair? If you have the old, damaged coupler from the case, I would repair your shaft at a discounted rate in exchange for the part. Thanks, Tom.

Triple X5

07-27-2010 11:36 PM

Yes sir thanks

Sent from my iPhone using Tapatalk

onseytote

07-31-2010 12:45 AM

Quote:

Originally Posted by Triple X5 (Post 756493)

I was driving on i95 in Florida just got off on to the exit slow down now I'm ready to hit the gas and go and all I heard was a loud metal to metal sound pull over and look underneath didn't see anything start it again put it in drive there goes the noise again call my mechanic told him and he it's the transfer case and front drive shaft
...

Working on the front drive shaft sometimes causes alignment problems. I think you'll need to mark if you're doing it yourself.

All times are GMT -4. The time now is 12:34 AM.

Page 2 of 10

Show 200 post(s) from this thread on one page