Xoutpost.com

Xoutpost.com (https://xoutpost.com/forums.php)
-   X5 (E53) Forum (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/)
-   -   Cranks good and engine start for 2sec on first start then only cranks (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/90210-cranks-good-engine-start-2sec-first-start-then-only-cranks.html)

broken 11-22-2012 05:20 PM

Cranks good and engine start for 2sec on first start then only cranks
 
Good battery
New ignition switch

4,4 v8

So today when i try to start the car it started on first attempt and dies after 2sec. No missfireing seems to run smooth and then just dies. Second attempt same. Third attemt i gave some gas and runed up to 3000rpm then dies.

Tried couple of hour later
Starts and dies after 2 sec. Second time only cranking.

So what to start with?

Try some start gas and see if its fuel related?
Check sparkplugs for spark?

After some reading here im guesing:
Fuelpumprelay?
Relay for DME?
Crank shaft sensor, or is this only in use after start up?

OR

I had the cheak engine light on the other day and had the codes cheaked out:
it was the preheating for the o2 sensor(lambdasond)
The indy errased it and the light whent away.


Please any ideas

broken 11-23-2012 11:02 AM

So hooked it up and did a ODB2 scan with key in position 2. Same code as before about the o2 sensor but nothing else.

I didnt get the vin number?

When I monitored the "live data" of the sensors with key in position 2 i get 0.0 on them and i get air intake temp to show.

When i was trying to start the car i get error on all off the sensor?

So please any ideas?

If any body knowes does a problem on the I-bus interfer with OBD2 scans?


All times are GMT -4. The time now is 10:46 PM.

vBulletin, Copyright 2026, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved.