Warning Light - Stopped Vehicle, will not restart

[Salty_Dog]

After Error Clean

# ERRORS IN UNITS
---------------------------------------------------------------------------------------------------------------------------
Unit BMWTNR HW SW-FSW ERRORS / SHADOW-MEMORY ERRORS AFTER CLEAR
---------------------------------------------------------------------------------------------------------------------------
EWS -> 6.988.104 05 02 1 error / 3 errors no errors / no errors
A/C -> 6.972.163 74 72 no errors
SRS -> 6.962.530 10 33 2 errors / no errors 1 error / 2 errors
IKE -> 6.979.578 27 23 5 errors no errors
LCM -> 6.961.140 08 77 2 errors / 7 errors no errors / no errors
ZKE -> 6.960.249 26 32 4 errors / 4 errors no errors / no errors
MFL -> 0.000.000 01 11 no data
AIC -> 6.923.954 40 32 no errors
RAD -> 6.976.961 04 45 no errors
TEL -> 6.987.546 12 76 no errors
VID -> 9.126.251 06 20 no errors / no errors
NAV -> 9.115.033 10 00 no errors / 3 errors no errors / no errors
VMGP -> 9.115.033 10 00 no data
BMBT -> 6.980.246 54 4A 2 errors 1 error
STH -> 8.381.207 01 17 2 errors no errors
SHD -> 6.955.925 C1 53 no errors / 5 errors no errors / 5 errors
AHL -> 6.934.837 06 07 2 errors / 4 errors no errors / 4 errors
SMF -> 7.119.868 05 15 1 error no errors


# ERRORS DETAILS - DTC(hex)/PARAM(hex)
---------------------------------------------------------------------------------------------------------------------------
EWS -> 0F/0A - Power on reset
Shadow-memory:
2A/34 - Error number 2A
23/02 - Toleration of changing code increased, key 2
0A/01 - Error number 0A

Errors after clear:

no errorsShadow-memory:
no errors

SRS -> 50/A0 - Power supply, undervoltage
70/A2 - Seat occupancy detector, break of seat mat

Errors after clear:

70/22 - Seat occupancy detector, break of seat mat
Shadow-memory:
50/20 - Power supply, undervoltage
70/20 - Seat occupancy detector, break of seat mat

IKE -> BD/D0 - Electronic braking-force distribution
F7/84 - No CAN message (DMER2)
F8/84 - No CAN message (DMER4)
F6/84 - No CAN message (DMER1)
F5/84 - No CAN message (ASC1)

Errors after clear:

no errors

LCM -> 0D/04 - Different results from redundant inputs
28/04 - Thermal oil-level sensor defect
Shadow-memory:
56/01 - Fuel injection system
59/01 - Transmission failsafe program
5B/1E - Level washer fluid
60/03 - Engine oil level, thermal sensor TOG
62/0A - MRS seat occupancy recognition fault
63/01 - Gearbox overheating
79/03 - Right low beam light

Errors after clear:

no errorsShadow-memory:
no errors

ZKE -> A4/1F - Mirror, potentiometer vertical or cable, driver's door
A7/04 - Mirror, potentiometer horizontal or cable, passenger's door
A0/1F - Open circuit mirror heating or cable, driver's door
A5/02 - Mirror, potentiometer horizontal or cable, driver's door
Shadow-memory:
80/23 - DWA-Alarm: Terminal R
83/02 - DWA-Alarm: door contact, driver's door
95/0F - Power up from the passenger's door module
94/0F - Power up from the driver's door module

Errors after clear:

no errorsShadow-memory:
no errors

BMBT -> 16/2A - EEPROM Checksum does not match with programmed value
01/0B - Watchdog reset

Errors after clear:

16/21 - EEPROM Checksum does not match with programmed value

STH -> 00/02 - Glow plug Flame detector
0E/08 - K-Bus Breakdown

Errors after clear:

no errors

SHD -> Shadow-memory:
9444/1F - Long-time low voltage
9640/82 - SoS Manual roof movement
9440/01 - Panic mode activation
9541/41 - SHD SKB activation
9641/81 - SoS SKB activation

Errors after clear:

Shadow-memory:
9444/1F - Long-time low voltage
9640/82 - SoS Manual roof movement
9440/01 - Panic mode activation
9541/41 - SHD SKB activation
9641/81 - SoS SKB activation

AHL -> 05/21 - Brake light switch defect
07/21 - Error WAKE-Line
Shadow-memory:
39/65 - Telegram Speed invalid
3A/65 - Telegram yaw rate invalid
3B/67 - Telegram steering angle invalid
3C/07 - Telegram status of lamp invalid

Errors after clear:

no errorsShadow-memory:
39/6C - Telegram Speed invalid
3A/67 - Telegram yaw rate invalid
3B/67 - Telegram steering angle invalid
3D/67 - Telegram Terminal status, timeout or invalid

SMF -> 12/03 - Steering-column radial, short

Errors after clear:

no errors


# CLEAR DTCS END
---------------------------------------------------------------------------------------------------------------------------