Control Arm Ball Joint Replacement

[andrewwynn]

Found some bad news. This is a quote from a company that MAKES special bushing for the other side of control arms:

When the ball joint at the wheel end of the arm is used up, the Moosehead UCAB can be easily pressed out of the control arm and pressed back into a replacement arm,

If a company that builds bearings for control arms moves their bushing to a new arm when the wheel side ball joint wears out it's not looking good for your prospect. Also when watching a video of meyleHD control arm fabrication they used the term "flanged" describing how the ball joint end is added this sounds like the steel of the arm is forged around the ball joint making it one with the end and not a part that can be removed and replaced.

The ball itself could be removed and replaced but are you going to get the next bigger ball?

I found examples with the aluminum arms where the ball joint can be pressed out for replacement but all signs are the wheel end is a permanent fix. Let us know if your find out otherwise and I'll cut mine in half maybe right though the middle of the ball for a post mortem that will answer at least is it possible. (eg if the steel is Forged around the ball joint forget it). My estimate is they made a trade off of size to make the end smaller made it staked on vs a pressed into solution.

I'm aiming for within a month to replace my arms with meyleHD as an upgrade to the stock arms (due to my proclivities of driving over curbs regularly).