|
|
|
|
||||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
|
#1
10-16-2006, 12:10 AM
|
||||
|
||||
|
Quote:
Good thinking! 
__________________
 
|
|
#2
10-16-2006, 12:19 AM
|
||||
|
||||
|
Sweeeet thanks for the info. I'll let ya know how I make out.
Oh does anyone know if these sensors are specific to X5's? And do I have to reset anything when i switch one? Shanks again.
__________________
Nobody cares what the definition of “is” is.
|
|
#3
10-16-2006, 01:37 AM
|
|||
|
|||
|
can we confirm this and make sure that the specific problem either comes from the front and or back
and also would u have to reset anything if u swapped one of the sensors?
__________________
|
|
#4
10-16-2006, 07:31 PM
|
||||
|
||||
|
OK have some kinda cool news here. I will try to write it up later to try and trouble shoot.
Here goes. If the beep is from the rear it IS one of the rear sensors. I took one of the good front (only the two center sensors will work, the side sensors have a different connector/ it has a 90 degree bend) So I took one of the front sensors and took one of the back sensors and swapped them out. Same result, beep from the back. I then moved to the other three sensor one by one until I found the bad one. Which was far right passenger side. I had to take each sensor and move it to the front as i tested them. When I took the bad sensor and plugged it to the front, the beep came from the front. And Bingo was his name ' O There ya go, Takes a bit of doing but it can be done. If you decide to try and take them out from the outside, be very careful. They are a biatch to get out without breaking. Much better to get them from the inside. One other thing. I have found out they use the same sensors on the 5 series and the 7 series. Not sure on year swapping or what year is good from what to what... still working on that. Like I said, I will try to take pics and do a write-up if anyone thinks it is worth it.
__________________
Nobody cares what the definition of “is” is.
|
|
#5
10-16-2006, 10:20 PM
|
|||
|
|||
|
Mine has also started doing this. Do you need to remove the front bumper to replace the front sensors?
I had a bit of a go trying to pry them out with my fingers but no luck.
__________________
Cheers Andy From Down under 2004 4.4i Sport Alpine White 2008 Toyota Land Cruiser Turbo Diesel (on order) 1993 Daihatsu Feroza SXP II 
|
|
#6
10-17-2006, 10:42 AM
|
||||
|
||||
|
Quote:
Were your phantom false positive beeps intermittent, or did it happen every time PDC was engaged?
|
|
#7
10-17-2006, 05:52 PM
|
||||
|
||||
|
It happened every time PDC was activated.
My friend says he has a list of years at work for me on what years mix with what year. I will post it when he sends it over 
__________________
Nobody cares what the definition of “is” is.
|
|
#8
10-18-2006, 12:17 PM
|
||||
|
||||
|
Ok here is the info on what sensors can interchange.
Also, I am getting a few PM's on how to remove them from the outside of the vehicle. I have used a Door Panel Clip removing too. It has been raining here but as soon as it clears up I will take pics and do a formal write-up on how to find and fix PDC Here is the chart for now. You should be able to buy them from an auto wrecker for around $20 - $30 Beats the $112 from the stealer. 
__________________
Nobody cares what the definition of “is” is.
|
|
#9
10-23-2006, 08:47 PM
|
||||
|
||||
|
Good work, I wanted to try that but was not sure if it would work. My dealer is gonna get me for one sensor I guess. It's there right now.
Quote:
|
|
| Bookmarks |
|
|
|
|
Hybrid Mode
