JL Stealth Box w/ amp... sound clip!

[chusteveb]

Originally Posted by cpatzer

Also I have an 18 inch spare so no go on the jack relocating. I am just going to either:

a) Find myself a smaller amp.
b) Build an amp rack.

Audison amps are good and small; I was going to try one of those if I couldn't find a place to mount the JL amp.

Also, I have a 19 inch spare and everything went back into place just fine with room to spare.

[chusteveb]

Originally Posted by digitaljok

I've always wondered what was behind here:


Any possible way to get an amp to fit in there? I've been worrying about amp mounting as well in anticipation of the stealthbox. All the info so far has been awesome!

Yeah, def no room back there; I looked. I think the gas filler routes down to the tank though some of that area.

[chusteveb]

Originally Posted by Dblock2151

Good to hear! Do you think the amp has enough room to breathe near the spare? I think I'll mount mine their aswell.

The amp will have plenty of air space to breathe just fine. It is not pushed up against anything nor is it mounted upside down. Amps are mounted this way all the time without any problems of overhearting.

[dkl]

Originally Posted by digitaljok

I've always wondered what was behind here:


Any possible way to get an amp to fit in there? I've been worrying about amp mounting as well in anticipation of the stealthbox. All the info so far has been awesome!

Chusteveb is obsolutely right that there's no room behind that area since that is the rear wheel well!

[dkl]

Originally Posted by chusteveb

From these images, it looks like you would have to remove the sub just to replace a light bulb? I so much want that sub...if I can only find a decent place to put the amp

[chusteveb]

Originally Posted by dkl

From these images, it looks like you would have to remove the sub just to replace a light bulb?

I'll have to check on this. If so, you would have to remove a stock sub just the same as both are the same size within mm if any.

[dkl]

Originally Posted by chusteveb

I'll have to check on this. If so, you would have to remove a stock sub just the same as both are the same size within mm if any.

I think the stock sub have a cut-out specifically for bulb changes, I believed.