Camshaft positioning sensor

KUCAK · #1 03-16-2007, 10:55 AM

I pulled the code and replaced the correct side. or so i thought, the SES light is still on. And the old sensor is in the trash. I am going to replace the other sensor. Are they the same? or is it a different sensor? searches online dont distinguish between sides. 1 size fits all is how they are saying it..

Sponsored Links

rayxi · #2 03-16-2007, 11:05 AM

They are not the same. Intake CPS and exhaust CPS are different and have different part numbers. The fault code should have indicated which one. Did you clear the code after replacing the sensor?

KUCAK · #3 03-16-2007, 11:07 AM

Code was cleared. then came on about 5 minutes after. I cant remember the fault but it was the passenger side. sensor.

KUCAK · #4 03-16-2007, 11:43 AM

PO348 Cam Position Sensor A Bank 2, High input.

This is the code. and i swapped the passenger side, and plan to swap drivers side..

Roc3b · #5 03-16-2007, 12:13 PM

They usually both go at the same time.

KUCAK · #6 03-16-2007, 12:40 PM

Yea, sounds about right. I will just replace the other side now..Where is a good place to get a new sensor? Noone seems to have any.

noncom23 · #7 03-16-2007, 08:01 PM

Link

Did you try these guys?

Sponsored Links