Quote:
Originally Posted by Ash977
UrbanFlow – were you able to fit those PDC supports on your car? I tried fitting the right corner one tonight with no success.
Should I put the two piece together first and then try to fit it on the bumper?
Appreciate any help.
|
Hi Ash,
Get your hand up behind the bumper and get hold of the back of the sensor.
This is fiddly and dirty and you can't see what you're doing so it's all done by feel.
Position the sensor so that it is central in the hole and the plastic lips line up to support it.
It's the actual housing that holds it all in place - so now push the housing cover into place whilst holding the sensor firm - very firm.
It takes some pressure to snap the two together - effectively clipping them together with the bumper plastic between the two.
There's no need to disconnect the sensor and even if you do you won't get any errors.
07-26-2011, 10:31 AM
Threaded Mode
