2001 x5 4.4 starts then dies.....HELP!!!!

[blakey2000]

upallnight,

this is EXACTLY where Im at, it senses a fault of "voltage too high" and cuts the fuel hense the start and stop. Problem is I cant clear the codes, the 3 pedal codes remain and it continues to do this. I can unplug the pedal and it runs in 'engine failsafe' which is rich, choppy and smilar to bad maf mode (since it runs in default limp mode)

not sure what to do

[blakey2000]

upallnight,

also at KL15 (igniton switched to pos. 2) I hear the throttle flap open and shut quickly, so it is talking to it. But thats it!

[blakey2000]

I see the adaption process. But I cant clear my codes to start this process.


"

EDK ADAPTATION
PROCEDURE:

When a replacement EDK
is installed the adaptation
values of the previous EDK
must be cleared from the
ME 7.2 control module.

1. From the Service
Function Menu of the
DIS/MoDiC, clear
adaptation values.

2. Switch the ignition OFF
for 10 seconds.

3. Switch the ignition ON
(KL 15). At approximately
30 seconds the
EDK is briefly activated
allowing the ME 7.2 to
“electrically learn” the
new component.
This procedure is also necessary after replacing an ME 7.2 control module. However, the

adaptation values do not require clearing since they have not yet been established."