X5 diesel engine noise - With VID.

[Dr. Anthony]

Alright, so I thought I would give an update to my issue. Long story short, its not solved yet. But here's what we did do.


Did a smoke test. Everything was good, except... where the wastegate is on the lower turbo. That's where you can see some soot escaping.. So the wastegate bushings/seals are gone.. and Looks like i'll need to pull the turbo off to get it rebuilt or swapped out.

I feel a bit of play. if I hold it closed, the noise goes away. Obviously I don't want to do this long term. I just wanted to see if I could replicate the noise while holding pressure on the wastegate so it doesn't move. Noise could NOT be replicated.

I also scanned for codes with a different machine and was able to get a few more out of it. I'll update the 1st post to show these for others searching.

they are:


4BB3: Nox sensor before denox cat- plausibility nox
4b6a: Nox sensor before denox cat - Plausibility
46B4: NOX Sensor before denox cat plausability nox.
4C04 - I think this could be EGT temp is too high (non-plausible)
4D16 - SCR system, efficiency: Efficiency too low
46A4 - NOx sensor after DeNOx cat., plausibility NOx: NOx signal offset too high at trailing throttle