DIY - Engine Partition Replacement

[doni01]

Originally Posted by Socale39

Awesome. How bad wee your pieces upon removal?

Hey bud, it's funny because I had seen your video right after I washed the engine last week and did not notice anything. Then Friday morning I did plugs/coils and that's when I saw them. They were all broken but the rubber strip was holding them in place perfect hence I could not notice them. I believe the new ones are redesigned because they seemed stronger than the flimsy ones I took out. Hopefully they will last Believe it or not, the hardest part of the job was putting those two little rivets in place. The ones they go one on each side. Had to spray the pins with some wd40 to slide them back in place. Overall a simple job.
Thank you again for the detailed video