|
||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
E70 Trunk Latch Rattle - Help Diagnosing This
Today I looked at the latch, and I noticed if I wrap my finger around the hook on the tailgate part, I can easily pull it and it makes the exact metal on metal noise I hear while on the road. I read that many people have noticed the hook area loose. I found mine to be relatively loose, so I used a 13mm combo wrench and tightened it, well. However, the noise is still there and I can still feel the play in the latch. While reading, I noticed some people say there were 4 screws, however, mine (2009) only has two. There are two holes in the back, but they don't appear to be threaded like the front two. It seems that if I was able to get four screws down, it would fix the issue, but it seems like the truck only uses two screws. Here is a picture ![]() So if I pull on that with my fingers, it can slide forward and back with some noticeable play and an annoying noise. The empty holes in the back do not have threading so I can't imagine anything fitting in there. I'm trying to buy time until my next service to get this looked at (3500 miles away), but I'm not sure I can stomach this anymore. It's quite embarrassing with customers and co-workers in the car. Any speed bump or reasonable bump in the road causes the trunk to make a very annoying noise. |
| Sponsored Links | |
|
|
|
|
#2
|
|||
|
|||
|
Forget about the hatch ! Open the bottom tailgate and if u look at the right and left hand corners just under the taillights u will see a "U" shaped latch on each side that secures the lower hatch when shut. Put felt or even electrical tape around the "U" shaped latches. This should make the noise go away.
|
|
#3
|
|||
|
|||
|
Thanks, I'll give that a shot!
|
|
#4
|
|||
|
|||
|
Quote:
|
|
#5
|
|||
|
|||
|
Hate to revive an old post but I did this and it works great!!
__________________
2008 X5 3.0si Monaco Blue/Grey Tech Package Cold Weather Package Premium Package Build Date: 02/2008 |
|
#6
|
|||
|
|||
|
Concurred! I just wrapped my u-shaped hinges in hockey tape and presto, no more trunk noise.
|
|
#7
|
|||
|
|||
|
couple months late, but I just fixed mine. Pop that small panel off (as you did before) at the catch on the side of the tailgate thats rattling, loosen both bolts, close the tailgate and push on the tailgate some so it is seated further at same time tighten those bolts.
|
|
#8
|
|||
|
|||
|
Felt tape around the u-hooks solved my rattle along with a replacement rubber seal around the opening.
|
![]() |
| Bookmarks |
|
|
|
|