my 1st post HID fogs with DIY

[Chillioil]

I have been searching around the forum but seems like I am the first one to install the HID fogs for the E70, and I will write a DIY along with my install progress. I bought the xtreme 6500K H11 conversion kit from kbcarstuff.com and Steve is a very helpful guy who answers some questions regarding how to fix the fault light code. Btw don't forget to use the coupon code: E90 when check out which will save you $25 plus a pair of failture fix resistor and nitrile dipped gloves
and here is the kit
1) Remover the cover under the fog light by pulling down the top of the silver trim and there should be 3 clips on top and 2 at the bottom. Remove the top first and then the bottom

2) Do the same on the other side
3) remove 4 black screws and 4 silver phillip screws under the bumper and 2 more black screws on each side of the fender liner(1 of them is quit hidden)

4) Remove the 5 screw on top of the bumper
5) now you can start to pull the whole bumper off but remember the bumper also held by 2 clips on each side also don't forget to unplug the PDC sensor wire

6) After the bumper is off then you can start wiring the harness
Ballast
Relay
failture fix resistor
7) Testing
8) check if there is any error code
9) make sure there is no error code before puting everythings back on and then you are all set

Should my first thread be sticky