NavCoder v2.3.5 released and now available - Page 8

Jaycee · #71 05-30-2008, 09:05 AM

Quote:

Originally Posted by Scuba

Jochen, did you find the solution of this problem? http://www.xoutpost.com/432109-post71.html

I was not so lucky like Jaycee today because of the same problem and did not knew his solution..... My Solution was the same as yours - disconnection of batery but of course this is not the most convinient way......

Anyhow THANK YOU for this program!!!! And good luck in future development ;-)

Scuba - Could you not locate the immobiliser code in the log file as I did?

Sponsored Links

Scuba · #72 05-30-2008, 09:17 AM

Quote:

Originally Posted by Jaycee

Scuba - Could you not locate the immobiliser code in the log file as I did?

Nope.... logging of IBus messages was disabled

1. I've disconnected computer from the I-Bus when I remembered to check this.....
2. I did not know that I could find it in IBus messages.....

Jaycee · #73 05-30-2008, 09:27 AM

OK, I understand. I assume you've now switched on the logging function in the NavCoder Tools menu now though?

Scuba · #74 05-30-2008, 09:31 AM

Sure..... now it switched on! ;-)

KiwiJochen · #75 05-30-2008, 12:27 PM

Quote:

Originally Posted by Scuba

But in this case (if we could not read this values) solution of Jaycee will not work, right? 'cause we'll not see this this code which was coded and which we can find now (like Jaycee wrote)..... And in this case would be only one solution - disconnection the baterry

am I right? could it happen that you'll disable this function but this bug will appear again?

No, you are wrong. Jaycee was viewing the logfile.

Removing the ability to read the adaptive values in the nav will not change the way NavCoder works.

ccfj1 · #76 05-30-2008, 01:36 PM

Well, I've had some success, I've managed to turn off the brake light bulb out and the indicator bulb out and this works perfectly, the side light bulb out says its turned off, but the bulb monitor will not turn off, so as soon as the side lights come on then the bulb warning comes on.

I've tested the bulb out warning with a normal bulb (in parallel) with the side light circuit, and the bulb warning stay out, (no warning).

I still get the disco show when I start the engine, so the check control must be doing something...

Anyway, onwards and up wards, I'll await the next version, and see if that has any fixes.

UCrewX5 · #77 06-04-2008, 09:43 AM

Version 2.4.0 now released. Closing this thread.

http://www.xoutpost.com/navigation-sy...-released.html

Sponsored Links