Home Forums Articles How To's FAQ Register
Go Back   Xoutpost.com > Search Forums
Reload this Page Search Results
Fluid Motor Union
User Name
Password
Member List Premier Membership Today's Posts New Posts

Xoutpost server transfer and maintenance is occurring....
Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management


Page 1 of 3 1 23
Showing results 1 to 25 of 57
Search took 0.01 seconds. Search: Posts Made By: utahx5
Forum: X5 (E53) Forum 01-06-2008, 03:52 PM
Replies: 61
Views: 9,743
Posted By utahx5
I work for a honda dealer here in salt lake city...

I work for a honda dealer here in salt lake city and there is a huge difference in bmw owners and honda owners I dont know how many times I have had a car in with 30,000 miles on it come in for its...
Forum: X5 (E53) Forum 11-28-2007, 05:18 PM
Replies: 1
Views: 1,194
Posted By utahx5
THIS IS WHAT ALLDATA CALLS FOR

WHEEL ALIGNMENT SPECIFICATIONS


Note: Given specifications are for car loaded down to normal position. Refer to Inspection Conditions See: Inspection Conditions...
Forum: X5 (E53) Forum 11-10-2007, 01:44 PM
Replies: 4
Views: 1,404
Posted By utahx5
I went with falken ziex z01 295/45/20 and...

I went with falken ziex z01 295/45/20 and 265/50/20 they ride nice and look good expecialy after I lowered the rear still need to get front springs and lower the front my spedo is off by 4 mph at 65
Forum: X5 (E53) Forum 11-09-2007, 07:16 PM
Replies: 27
Views: 17,931
Posted By utahx5
They make plastic brake line clamps they are...

They make plastic brake line clamps they are cheap I do several brake jobs a day and always use them as far as air in the abs pump go out lay on the brakes and make the pump cycle I have done this...
Forum: X5 (E53) Forum 11-08-2007, 06:29 PM
Replies: 14
Views: 5,010
Posted By utahx5
I'm with jcl sliders on calipers worn and let the...

I'm with jcl sliders on calipers worn and let the caliper move
Forum: X5 (E53) Forum 11-08-2007, 11:00 AM
Replies: 3
Views: 1,052
Posted By utahx5
My guess would be alternator also pcv valve is a...

My guess would be alternator also pcv valve is a common humm noise
Forum: X5 (E53) Forum 11-07-2007, 12:59 PM
Replies: 23
Views: 4,679
Posted By utahx5
Yes they will work yhe spec sheet said 9 inch to...

Yes they will work yhe spec sheet said 9 inch to 11 inch bridgstone blizzak dm-23 265/50/20 are about 100 bucks less
Forum: X5 (E53) Forum 11-05-2007, 11:00 AM
Replies: 23
Views: 4,679
Posted By utahx5
The staggard tires need to have the same...

The staggard tires need to have the same revolutions per mile and I dont think the sizes you posted are
Forum: X5 (E53) Forum 11-01-2007, 10:01 AM
Replies: 13
Views: 2,967
Posted By utahx5
I PUT STREIGHT PIPES ON AND IT SOUNDED TERRABLE...

I PUT STREIGHT PIPES ON AND IT SOUNDED TERRABLE PLOP PLOP PLOP OUT THE BACK I THEN DID THE X PIPE SMOOTH AND MUCH BETTER SOUND
Forum: X5 (E53) Forum 10-28-2007, 11:49 PM
Replies: 7
Views: 1,648
Posted By utahx5
spark is spark but Iridium will last much longer

spark is spark but Iridium will last much longer
Forum: X5 (E53) Forum 10-25-2007, 11:43 PM
Replies: 8
Views: 1,247
Posted By utahx5
some codes must be cleared and some codes will...

some codes must be cleared and some codes will self check and light will go off sometimes it has to self test and be ok something like 30 times before the light goes off
Forum: X5 (E53) Forum 10-25-2007, 10:13 AM
Replies: 7
Views: 1,339
Posted By utahx5
Lots of manual transmissions take atf they use it...

Lots of manual transmissions take atf they use it because it is thinner and less friction so you get better gas mileage
Forum: X5 (E53) Forum 10-25-2007, 10:07 AM
Replies: 21
Views: 10,216
Posted By utahx5
Read

Engine - MIL ON/Codes Set/Tapping/Rattling NoiseNotes...
Forum: X5 (E53) Forum 10-25-2007, 09:59 AM
Replies: 97
Views: 20,202
Posted By utahx5
Will these work with xnon factory lights

Will these work with xnon factory lights
Forum: X5 (E53) Forum 10-24-2007, 04:43 PM
Replies: 5
Views: 4,431
Posted By utahx5
I think it may be P0335 crank sensor code

I think it may be P0335 crank sensor code
Forum: X5 (E53) Forum 10-23-2007, 10:06 AM
Replies: 1
Views: 954
Posted By utahx5
Yeah Yeah Yeah I need those too

Yeah Yeah Yeah I need those too
Forum: X5 (E53) Forum 10-23-2007, 10:01 AM
Replies: 4
Views: 1,025
Posted By utahx5
Pull the regulator out unbolt the motor plug it...

Pull the regulator out unbolt the motor plug it and the switch back in and see if the motor runs (check the thread about the air bag if you have to unplug it)
Forum: X5 (E53) Forum 10-21-2007, 12:00 PM
Replies: 21
Views: 10,216
Posted By utahx5
kelsvile try bleeding the air out of the system...

kelsvile try bleeding the air out of the system let the car warm up to full temp run it in neutral at 2500 rpm for 5 minutes let it idle for 5 minutes then do it again at 3000 rpm for 5 minutes
Forum: X5 (E53) Forum 10-21-2007, 11:53 AM
Replies: 3
Poll: Vanos Noise
Views: 1,455
Posted By utahx5
Mine did that really bad every time I started it...

Mine did that really bad every time I started it cold I changed to modile one ow- 40w synthetic and it has only done it once in the last month and only for half second try it and post you're results...
Forum: X5 (E53) Forum 10-03-2007, 04:28 PM
Replies: 4
Views: 1,758
Posted By utahx5
Year make model engine size please you might try...

Year make model engine size please you might try to clean the mass air flow sensor
Forum: X5 (E53) Forum 10-02-2007, 09:02 PM
Replies: 11
Views: 3,339
Posted By utahx5
hi are you there

hi are you there
Forum: X5 (E53) Forum 10-01-2007, 10:05 AM
Replies: 21
Views: 10,216
Posted By utahx5
I was running castol gtx 5w-30w

I was running castol gtx 5w-30w
Forum: X5 (E53) Forum 09-30-2007, 11:42 AM
Replies: 11
Views: 3,339
Posted By utahx5
squirt a little penetrating oil in the hole...

squirt a little penetrating oil in the hole (anything that says catalist is the best) warm motor up and go for it like tomaz said use high quality six point socket only good luck
Forum: X5 (E53) Forum 09-30-2007, 11:37 AM
Replies: 21
Views: 10,216
Posted By utahx5
4.4 Dry start knock mobile1 0-40

Ok my test has begun my 2001 4.4 with 70,000 miles has been doing the dry start knock only twice this summer but one it got cold it knocks for about 2 seconds almost every morning I changed my oil...
Forum: X5 (E53) Forum 09-28-2007, 06:19 PM
Replies: 5
Views: 1,136
Posted By utahx5
Mine stays on also

Mine stays on also
Showing results 1 to 25 of 57
Page 1 of 3 1 23

 
Forum Jump


Contact Us - Xoutpost - Sponsors - Archive - Top

All times are GMT -4. The time now is 08:19 AM.
vBulletin, Copyright 2026, Jelsoft Enterprises Ltd. SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved. Xoutpost.com is a private enthusiast site not associated with BMW AG.
The BMW name, marks, M stripe logo, and Roundel logo as well as X3, X5 and X6 designations used in the pages of this Web Site are the property of BMW AG.
This web site is not sponsored or affiliated in any way with BMW AG or any of its subsidiaries.