Ask Detailer's Domain

[tmv]

What 's your opinion about Adam's MP1 & 2? I need to give the polish rims on my HRE wheels some loving. Would you recommend something else?
Thanks in advance Phil.

[detailersdomain]

they are great!

[HFD-Chase]

Hey Phil, I need to get a wheel brush for my X5, which would would you recommend? Also I need to get some microfiber towels as I have none. I was planning on a couple of the Uber All purpose. Is that a good start? Do I really need all the different kinds? Alsoooooo, any chance on a deal of the day on the microfiber towels coming up?

[detailersdomain]

Originally Posted by HFD-Chase

Hey Phil, I need to get a wheel brush for my X5, which would would you recommend? Also I need to get some microfiber towels as I have none. I was planning on a couple of the Uber All purpose. Is that a good start? Do I really need all the different kinds? Alsoooooo, any chance on a deal of the day on the microfiber towels coming up?

here is a great deal.

https://detailersdomain.com/Uber-All...ack_p_330.html

Phil

[FSETH]

Phil,

What is the best way to apply the Iron Cut? Should I just spray it on the whole car after washing and let it sit for 5 minutes or so? Or, do I actually need to rub it in a little bit with a sponge or something?

**EDIT** Please disregard. I got this straight off your website:

1. Wash the car or wheels surfaces, make sure surface is cool.
2. Shake well, spray on the surface, rub it in with damp sponge thoroughly, wait 5 mins while contaminants change its color to purpel / red, wipe off with damp soft sponge. Don’t let the Iron Cut dry completely on surface!
3. Rinse well or power wash the whole surface. Car is now ready to clay!

[detailersdomain]

yup you got it. some agitation would help

[Ricky Bobby]

Phil 2 questions, what pad speed to use with a PC (older one not XP) and D300?

And if I don't have a compressor to blow out the MF pads at the moment what would you suggest to keep pads clean? Or is it possible to use 2 pads on one car and just wash them afterwards?

some sites are saying to clean the pads out after every section or panel you do, I'm wondering if i can get away with another method or just going through a pad for half the car and doing the other half with a fresh pad?

[detailersdomain]

Originally Posted by Ricky Bobby

Phil 2 questions, what pad speed to use with a PC (older one not XP) and D300?

And if I don't have a compressor to blow out the MF pads at the moment what would you suggest to keep pads clean? Or is it possible to use 2 pads on one car and just wash them afterwards?

some sites are saying to clean the pads out after every section or panel you do, I'm wondering if i can get away with another method or just going through a pad for half the car and doing the other half with a fresh pad?

sure thing you can go to

speed 5 to 5.5 on that

2 pads should get the car done.

clean the pad with the below.
https://detailersdomain.com/Meguiars...ush_p_661.html

Phil

[Ricky Bobby]

youre the man thank you!

[detailersdomain]

thanks!