|
|
|
|
||||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
|
#1
07-13-2021, 08:21 PM
|
|||
|
|||
|
I'm putting the underdash cage back in place and connecting a steering wheel is kinda tricky.
I dont remember the position it was in, I didn't mark it, and my wheels are not straight. So I got lucky. When I was removing it, I tried to stick in a screw driver to remove the shaft. https://imgbb.com/RYv2r8F Accidentally I ended up marking the steering column, which is good. I can now align it according the the same mark on the piece that inserts inside 
|
|
#2
07-13-2021, 11:42 PM
|
|||
|
|||
|
Hardwiring camera. I kept the cigarette lighter of the camera to plug it in because it had an extra fuse inside.
I hardwired it to Fuse #14 which always has power It's pin 16 on the connector Fuse 14 is Multifunction control module 1, whatever that is         
|
|
#3
07-13-2021, 11:52 PM
|
|||
|
|||
|
Installed the cage back
            I want to test everything now before moving on with the center console and the dash. I screwed something up. Cannot remove key from ignition and no crank no start condition. Probably forgot to connect something
|
|
#4
07-14-2021, 01:12 PM
|
|||
|
|||
|
Forgot to connect this cable
 Now I can remove the key and change gears. New challenge. No crank no start condition. Probably loss of sync between EWS and DME was my first thought. So I disconnect EWS and put a fuse in ews connector, pin 1 and 2. Car cranks. Now is the perfect time to delete EWS from DME, update DME firmware and install the remote starter.
|
|
| Bookmarks |
|
|
|
|
Hybrid Mode
