2005 BMW X5 3.0i remote start install diy?

[E533.0i]

Hello guys,I'm new here.My wife has been nagging me to put a remote start in her bmw x5.So I recently purchased a rs1050 unit,ordered a factory key ring antenna.Im planning on making my own bypass.

Is it safe to assume I can use the factory key ring antenna i ordered and a spdt relay as a bypass in this car??Also according to the RS1050 I see wires labeled:

12v= I would assume this is 12v constant at the ignition cylinder?
Starter=I would assume this is for the starter wire also at the ignition cylinder??
Accesory=I would assume this is for accessory position at the ignition cylinder??

I dont have a problem with those I think im correct in my assumptions.

However I do see ignition 2 and accessory 2 listed on the module itself as well.Just wondering if anyone has wired one of these and what I need to use and dont need to use??

I am hoping to tap the yellow/red wire at the center console to lock and unlock the door using factory remote and activate the remote start this way as well.According to the unit it needs to see 2 negative pulses within 5 seconds of each other to start or stop the engine.

Any other issues i might run into??Im not an installer of these systems so Im just looking for some help if any of you have done this.

Here is the link to the paper work I got with this unit:

http://files.thehoffmangroup.com/ins...ons/RS1050.pdf\


Ive done a search on this.There seems to be nothing solid on this topic or any DIY.