its simple to fit i did mine after downloading the PDF instructions given on this site. there is a few things you need to pay close attention to. when your fitting the front apron frame you need make sure you 100% get it bang on in the middle of the bumper otherwise the two outer parts wont fit flush against the bumper.
other than that everything else is simple an straight forward on the front.
the instructions mentioned something about a heat gun to form the front kit but didn't need to use any of that.
the rear is the same principal make sure you get the rear sub frame 100% in the middle other wise the outer parts don't line up properly.
ignore the time it says on the pdf for install that only applies after you installing a few cause it took me about 1.hr 45 mins. just take your time installing and follow the instructions carefully but the key is the middle sub frame must be in the middle an when your finished you'll have a big smile on your face... the car will then look the business
thanks to the pdf instructions being posted on this site
12-24-2009, 07:18 PM
Threaded Mode
