|
|
|
|
||||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
#12
06-07-2013, 01:27 PM
|
||||
|
||||
|
Neil, which interior light set did you buy?
__________________
 "Lapit mga kaibigan at makinig kayo, ako'y may dala-dalang balita galing sa bayan ko Nais kong ipamahagi ang mga kwento at mga pangyayaring nagaganap sa lupang ipinangako..."
|
|
#13
06-07-2013, 10:01 PM
|
|||
|
|||
|
just got my '07 3.0Si back
i was having some delay with acceleration in lower RPM's they found the tranny sleeve seal leaking and oil filter housing gasket leaking looks like they replaced oil filter housing too??.. showing a price of $472 so i'm sure the gasket itself is not that price. replaced oil pan and filter, oil filter stand gasket so warranty covered that then of course there's more coolant hose was starting to dry rot along with the vent piping.. $160 they charged me for refilling anti-freeze.. $23 charged me for atf synthetic.. $59 charged me for windshield washer fluid.. $7 replaced left brake light blub... $4 after warranty i ended up paying $430.. not too impressed as i sent it in thinking everything would be covered by warranty was done at an Indy shop because of warranty we can't pick and chose where to have it repaired really *EDIT* the guy came back and dropped the key off took it too the gym and back, seems to be fixed  now i wonder if i should still get a sprint booster Last edited by Mr.X5_3.0si-retired; 06-08-2013 at 07:27 PM.
|
|
#15
06-15-2013, 01:39 PM
|
|||
|
|||
|
Installed the Lux V4 angel eyes. Very pleased with the results. However, installation became a process in that the left bulb was absolutely fused at the gasket. Ended up twisting off the end and from there it was a giant mess. Ended up drilling two holes with a Dremel tool to insert two steel pins to be able to create leverage. On further twisting more disintegration and more of a mess. Became a dismantling piece process and then a delicate piece removal process including using a magnet and a special attachment to my shop vacuum to try the best I could to clean up my mess. Wonder what I could and should have done differen? Heat gun, or WD-40? Obviously hoping not for a repeat but it would be good to save someone else.
|
|
#18
08-23-2013, 03:49 PM
|
|||
|
|||
|
just got some 22" Vossen VVS082's with custom paint (Chrome Metallic Special Effect Paint) put on
 
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
|
|
Linear Mode
