Okey. I see..

Any tip on where i can find the 2.7 vversion.?

I googled it without any luck.. The only link on the forum i can find is for 2.6

Hunt, it's there somewhere

I can not for the life of me find the 2.7 software..!!

Is it a payware.? Or is it not supposed to be available for ordinary people.?

I gave you the link to 2.7 in your separate topc... Good luck

Okey.

I have edited all the file in the dutch lang file and replaced them with the english.

Can i then just make a iso file from the new edit os files and burn on a cd..?

I found your guide on bimmerforum, and followed your procedure.

When i put the cdd in the nav it said it was an invalid disk and ejected it..

Is that because its not reading the cd, or because i did something wrong setting it up.?

What and how you've done? Step by step...

Okey.

I downloaded the 27v.

I loaded the mdf image with daemon, and copied the whole content to my hard drive.

Then i opened usw_load file ound under Mk3\0116\BMWC01S\app_sw folder.

I replaced the language in the deutsch folder with the english language with navtweak 2.7, and saved the file in the smae location as before.

Then i installed an hex editor and edited the two files, sw_rel.tbl and lng_rel.tbl found under the Mk3\0116\BMWC01S\ folder. I changed the last line on the top to 0640app sw/.
(I have never done this before, so i really dont know if i did it right.)

Then i used mode2cdmaker to make a bin and cue file with all the edited files. Afterwards, i burnet a cd at 1x speed using imgburn.

According to img_burn, the image was a Mode2/form1 file.

When burned and checked, found no errors, i tried it with the nav system.

Thanks for all the help guys..

Don't extract all the image.... It is enough to take only app_sw and *.tbl files and then insert it into the image and save the image.......

I think this is the reason of error