|
|
|
|
||||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
11-22-2009, 03:20 PM
|
|||
|
|||
|
16:9 Monitor - Flip Screen Problem
When I was doing the Nav retrofit I had to remove the monitor to make the CD changer connections. I ordered the removal tools from BMW (only £2.50) to make the job easier. To release the bottom clips you need to flip the screen down via the eject button and you then have about 15 seconds to release the tabs. I ran out of time and the screen caught on the release key I managed to get the screen opened again and removed the key. My problem now is when I press the eject button the screen comes down but doesn't stay down long enough to eject the CD. If I keep my finger on the flip it then stays down but still can't get the CD out. Anyone else have this problem? Cheers D 
|
| Sponsored Links | |
|
|
|
|
#2
11-23-2009, 05:39 AM
|
||||
|
||||
|
Not seen this one before David, try popping the fues for a few minutes and seeing of the HU resets itself.
__________________
Sept 03, M3, Silver Grey. Retro-fits: Modded Mk4 DVD Drive, OEM Bluetooth, VR Control, Rainbow Speaker Upgrade, Sony SOT Amp, HK Sub, CCFL, Intravee II, NightMode.
|
|
#3
11-23-2009, 09:23 AM
|
|||
|
|||
|
Cheers John. I took the monitor out last night and discovered one of the retaining springs was badly bent and was catching on the screen when it came down. I managed to straighten it out and the screen now flips down smoothly - which is a start! However, the screen just comes down and immediately closes again without ejecting the disc.
The CD still plays and I have an Intravee so it's not the end of the world if I don't sort it but it's just annoying. You don't happen to know which fuse I need to pull by any chance? Cheers D
|
|
#4
11-23-2009, 09:44 AM
|
||||
|
||||
|
Not off the top of my head mate, but it should be the one you installed into the fuse box when you retrofitted mate.
__________________
Sept 03, M3, Silver Grey. Retro-fits: Modded Mk4 DVD Drive, OEM Bluetooth, VR Control, Rainbow Speaker Upgrade, Sony SOT Amp, HK Sub, CCFL, Intravee II, NightMode.
|
|
#5
11-23-2009, 09:47 AM
|
|||
|
|||
|
Hmmmmmm ... didn't fit a fuse during the retrofit. I'll try disconnecting the battery for a while but might have to leave it for a few days as I managed to run it flat last night and needed a push from a very helpful neighbour
|
|
#6
11-23-2009, 10:02 AM
|
||||
|
||||
|
be careful with letting the battery go flat mate the nav computer don't like it.
__________________
Sept 03, M3, Silver Grey. Retro-fits: Modded Mk4 DVD Drive, OEM Bluetooth, VR Control, Rainbow Speaker Upgrade, Sony SOT Amp, HK Sub, CCFL, Intravee II, NightMode.
|
|
#8
11-23-2009, 10:10 AM
|
||||
|
||||
|
Good man, check you cutters PM mate
__________________
Sept 03, M3, Silver Grey. Retro-fits: Modded Mk4 DVD Drive, OEM Bluetooth, VR Control, Rainbow Speaker Upgrade, Sony SOT Amp, HK Sub, CCFL, Intravee II, NightMode.
|
|
| Bookmarks |
|
|
|
|
Linear Mode
