Home Forums Articles How To's FAQ Register
Go Back   Xoutpost.com > Search Forums
Reload this Page Search Results
Fluid Motor Union
User Name
Password
Member List Premier Membership Today's Posts New Posts

Xoutpost server transfer and maintenance is occurring....
Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management


Page 2 of 2 1 2
Showing results 26 to 37 of 37
Search took 0.02 seconds; generated 71 minute(s) ago. Search: Posts Made By: Rewmer
Forum: X5 (E53) Forum 06-16-2012, 03:58 PM
Replies: 11
Views: 5,775
Posted By Rewmer
Hesitation on light throttle

2002 4.4.

As the title says, I have an issue with a missfire / hesitation on light throttle openings. It manifests itself after a few miles from start up and only seems present on very light...
Forum: X5 (E53) Forum 05-10-2012, 05:32 PM
Replies: 12
Views: 3,105
Posted By Rewmer
Rough idle can be a sign of a failed PCV valve on...

Rough idle can be a sign of a failed PCV valve on the back of the inlet manifold. If the hoses where bad enough to warrant changing then it a good chance the valve has failed or is failing. There is...
Forum: X5 (E53) Forum 05-09-2012, 04:39 PM
Replies: 6
Views: 2,424
Posted By Rewmer
coils should show between .4 and .7 mega ohms...

coils should show between .4 and .7 mega ohms measured between the two outermost connections.
I would start with the plugs and at the same time check for oil pooling in the plug wells. Check the...
Forum: X5 (E53) Forum 05-07-2012, 01:10 PM
Replies: 13
Views: 4,803
Posted By Rewmer
You can check the coil with a multimeter. Set it...

You can check the coil with a multimeter. Set it to ohms and pit the probes on the outer two contacts. You should have a reading of .4 to .7 mega ohms or there abouts . Anything out of that range and...
Forum: X5 (E53) Forum 04-28-2012, 02:57 AM
Replies: 3
Views: 1,648
Posted By Rewmer
Take a look at the cam sensors to start with.

Take a look at the cam sensors to start with.
Forum: X5 (E53) Forum 04-26-2012, 03:06 PM
Replies: 10
Views: 19,785
Posted By Rewmer
The Engine ECU in your X learns . It bases its...

The Engine ECU in your X learns . It bases its fuelling on the inputs from the MAF, crank,cam, knock, etc sensors and then the resultant output from the O2 sensors. Over time it learns the best...
Forum: X5 (E53) Forum 04-23-2012, 05:09 AM
Replies: 2
Views: 1,572
Posted By Rewmer
As you suggested to someone else......

As you suggested to someone else......
Forum: X5 (E53) Forum 03-15-2012, 04:03 PM
Replies: 4
Views: 2,136
Posted By Rewmer
As above, you need to take the plug out of the...

As above, you need to take the plug out of the radio module behind the battery and plug you cable into the loom that you have just disconnected.
Forum: X5 (E53) Forum 01-29-2012, 07:16 PM
Replies: 9
Views: 1,889
Posted By Rewmer
I've got a 95 litre tank in the spare wheel well....

I've got a 95 litre tank in the spare wheel well. The compressor is re-located to the right hand rear panel where the sub would go if I had one. Go for a Prins or brc system and make sure the fill...
Forum: X5 (E53) Forum 01-27-2012, 04:27 PM
Replies: 6
Views: 2,937
Posted By Rewmer
The memo on off is on one of the setup screens on...

The memo on off is on one of the setup screens on the nav .
Forum: X5 (E53) Forum 01-02-2012, 05:22 PM
Replies: 8
Views: 4,010
Posted By Rewmer
It was on my list of must haves when looking for...

It was on my list of must haves when looking for my current x, but have found its not as usefull as expected. There is alway a bag of shopping that falls of the back when pulling it out.
Forum: X5 (E53) Forum 01-01-2012, 06:36 PM
Replies: 6
Views: 4,823
Posted By Rewmer
As far as i can see all the later n62 2004...

As far as i can see all the later n62 2004 onwards use the Bosch ME 9.2.1 engine managment ap your theory seems to sound, you may have trouble if you have the earlier single vanos ME7.2
management.
Showing results 26 to 37 of 37
Page 2 of 2 1 2

 
Forum Jump


Contact Us - Xoutpost - Sponsors - Archive - Top

All times are GMT -4. The time now is 07:25 PM.
vBulletin, Copyright 2025, Jelsoft Enterprises Ltd. SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved. Xoutpost.com is a private enthusiast site not associated with BMW AG.
The BMW name, marks, M stripe logo, and Roundel logo as well as X3, X5 and X6 designations used in the pages of this Web Site are the property of BMW AG.
This web site is not sponsored or affiliated in any way with BMW AG or any of its subsidiaries.