Xoutpost.com

Xoutpost.com (https://xoutpost.com/forums.php)
-   X5 (E53) Forum (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/)
-   -   3.0d only priming intermittently (https://xoutpost.com/bmw-sav-forums/x5-e53-forum/111947-3-0d-only-priming-intermittently.html)

Kshamm 06-21-2020 12:06 AM

Hahah. Yes phase one is now complete. Car doesn’t start ever now

Clavurion 06-21-2020 06:20 AM

So is the temp gauge now always jumping to red when you turn on ignition? Can you connect to all modules with diagnostics and what are the trouble codes? If DDE is powered and you can connect normally with diagnostics that temp gauge behaviour must be caused by failed CAN-bus connection between DDE and instrument cluster.

Kshamm 06-21-2020 06:29 AM

Yes temp gauge goes straight to red. 12v was showing on cam sensor when turning the ignition to position 2. I have a Foxwell scanner. I have not scanned for codes since the fault has become permanent. I will do what you suggested tomorrow and see what comes of it. It also (not everytime though) has a gearbox overhearing warning flashing up which I hadn’t had before.

Kshamm 06-21-2020 06:34 AM

Could it have anything to do with the temp sensor?

Clavurion 06-21-2020 11:44 AM

Quote:

Originally Posted by Kshamm (Post 1186347)
Could it have anything to do with the temp sensor?

The gauge showing could of course be caused by failed temp sensor but that is very very rare on these and it would not cause any other symptoms.

andrewwynn 06-21-2020 02:42 PM

Run the auto scan on foxwell. It does a better job of finding module erorrs.

Kshamm 06-25-2020 10:32 PM

Rescanned today on a few recommendations and below is what I found.

I did a scan and heaps of codes popped up so I deleted and scanned again.

Another thing I noticed today was when I turned it over to try and start the temperature gauge started to drop back down to cold.

-EGS Transmission management 5140 No message receiver EGS transmitter DME-DDE. I think is is related to the trans fail safe warning that is coming on as a result of the original issue.

-IKE instrument cluster electronics- IKE signal line disturbed


Do these codes offer any possible reasons to anyone?

andrewwynn 06-25-2020 11:21 PM

It's saying there is a wiring problem. Short or open


Sent from my iPhone using Tapatalk Pro

Kshamm 07-11-2020 11:37 PM

Ok still no luck. How the hell do I find a “wiring” problem?

andrewwynn 07-12-2020 01:17 AM

Start with cleaning the connectors everywhere. TCM DME and importantly the transmission connector. Not sure how different those are on the diesel model but everything relies on them. You may find a bundle of wires that mice have turned into a nest


Sent from my iPhone using Tapatalk Pro


All times are GMT -4. The time now is 10:35 AM.

vBulletin, Copyright 2026, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0
© 2017 Xoutpost.com. All rights reserved.