Originally Posted by ericpablo-e53 (Post 1066231)

I have factory nav also, and want to install an eonon unit. Can i remove the old harness? Because someone wants to buy my 16:9 screen and mk3.. and he asked for the harness as well

Originally Posted by crystalworks (Post 1066260)

I don't remember exactly. Might try my Avin install thread to see what was required to plug into what. Sorry, lol, getting older sucks as my memory is not as sharp as it used to be.

Originally Posted by johnlacson (Post 1066311)

How do these units stand up to sub-zero temp? (-5ºF/-20ºC) Do they introduce any more battery drain when the car is switched off?

Originally Posted by jeffb325 (Post 1035426)

X5only,

The issue you are having is that there are two slots on the back of the dynavin that interlock with the bracket, with the dynavin out of the car you can see plainly how the unit interfaces with the bracket. When you mount the bracket you are screwing to the dash....which is mostly foam and vinyl...and is not very precise. So if the brackets dont end up in the right place the brackets wont line up with the slots, and the unit wont go all the way in.

There are a few options, get the brackets lined up better, sometimes not tightening the screws very tight helps as it keeps things from getting warped and allows for some wiggle when you are putting things together....although sometimes easier said than done depending on how far away from "standard" your dash is. OR just cut or bend that part of the bracket back out of the way so that it no longer hits the back of the dynavin. Those slots are basically redundant and dont really need to be there as the head unit is already securely held in a couple other ways as well.

Because a picture is worth a thousand words....


This is a pic looking at the bracket and the BOTTOM of the dynavin, you can see the slot and the part of the bracket that goes into it
http://img.photobucket.com/albums/v1...psjl3dydff.jpg

This is probably what yours is doing, its slighting misaligned in the dash and is not going in all the way.
http://img.photobucket.com/albums/v1...psddqtukmz.jpg


This is what it should do when everything is lined up correctly
http://img.photobucket.com/albums/v1...ps54y5fyof.jpg

Originally Posted by Gurjit (Post 1071760)

bending them to a certain angle is the only way, takes a lot of fiddling to get right.
Currently my navi has stopped working, keeps poping "fetal error" codes, went through the crash log and the info says cannot find "mobilenavigator.maps"
on my last step with the naviextras support team, if it fails I have a bad head unit :(

Originally Posted by X5only (Post 1071770)

They probably meant a bad nav micro sd card. Have you tried with a different one?

Originally Posted by X5only (Post 1051093)

How do I have the unit default to displaying navigation on startup? I want it to always be on the nav screen unless I make a different selection. The Eonon unit on my E39 defaults to what was last displayed when the ignition is turned off -radio, nav, dvd, usb etc.