Dreaded trans. Failsafe prog.

[Oldmactech]

Doing about 60 yesterday and the abs/DSC light came one, pulled off to the side and trans.failsafe light came on and all I could do was limp mode. On my way to an important meeting. Switched off and back on and was able to drive the last Mike or two but no torque and didn’t shift properly. Got it back home and getting odd codes. All 4 oxy sensors, MAF low voltage , ICV mechanical failure.

Also 5A brief Power interrupter76, DME/DDE does not fulfill Torque request 3A no message from EGs control unit.

Suggested that I replace the battery but it’s 12.7 at rest and 14.17 running. Suggest to me that battery (less than a yr old) and the alt are good.

I also disconnected the ABS cable but no apparent effect.

I’ll check the fluid on Monday but I also smelled a burned smell but in heavy traffic, who knows.

Any diagnostic tips would help.

Thanks.


Sent from my iPad using Tapatalk