Complex EMF module problem need expert help

[Mackskibum]

Two fold. When I re-pinned the connector, I reversed 2 pins. This was complicated by the fact that one of the terminals on the motor inside the actuator had broken off. I put the pins in the correct location and replaced the actuator and all has been good.

Used Rheingold to clear errors. It cleared, I actuated the brake, it reappeared, cleared a second time and all has been good.

[Mackskibum]

Posted but some reason didn't stick. I had 2 issues-

1. When I re-pinned the connector, I reversed two pins. I did this after the replacement actuator stopped working and doubled up my problem. I corrected this issue and the actuator was still inop.

2. I replaced the replacement actuator and did forensic research. That failure was caused by one of the motor tabs being broken.

I cleared the error using Rheingold. First clear and the error came back after one engagement. Cleared the second time and has been good since.