|
||||||||
| Xoutpost server transfer and maintenance is occurring.... |
| Xoutpost is currently undergoing a planned server migration.... stay tuned for new developments.... sincerely, the management |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|||
|
__________________
'06 X5 3.0i - bought @143,123 miles (12/26/20) |
| Sponsored Links | |
|
|
|
|
|||
|
new lower balljoints(left was junk) and while I was at it new front rubber bushings since the arms were off, and everything had 120K miles on it since I last replaced it. Also found left front CV boot torn, and new CV as it was lifetime warr.
Still have a random front end vibration, normally at higher speed, 60+ but some times not till over 80, but then doesnt smooth out even under 60, but it comes and goes, not triggered by anything I can pinpoint. Wheels have been balanced and since its random probably not it. Last spring was lower control arms and they are still tight. Next thing is strut mounts and thinking the left front strut is dead?
__________________
2004 X5(E53) 3.0L 1999 M3(E36) 2003 Z4(E85) 3.0L |
|
|||
|
Quote:
In my experience high speed vibration is usually wheel or tires. Have you checked for a bent wheel? Also sometimes tires will balance on the machine but still vibrate (imagine a tire that has a "hard spot"). Some shops have a special road force balancer that can help in these cases. It can feel random. I think it's because of the two tires in the front of the vehicle interacting with each other. Imagine if both tires were out of balance in opposite directions - it would feel smoother than if they were out of balance in the same direction. Because no two tires are exacting the same diameter (and because no road is 100% straight) they will change interactions as you drive.
__________________
2003 X5 3.0i MT, White, 161k |
|
|||
|
not balance or bent, I watched while one of my shop guys did them.
also zero pulse in the brake pedal, but I can some times get the steering wheel pulse going by hard braking. Just pulled the top cap and ran the nut off the strut mount, still looks almost new. next up, check the strut.
__________________
2004 X5(E53) 3.0L 1999 M3(E36) 2003 Z4(E85) 3.0L |
|
|||
|
Quote:
|
|
|||
|
Yep, thrust arm bushings and the ball joint were both replaced.
Strut mount looked fine from the top when I removed the nut so I put it up in the air and removed the strut tonight. once I got the spring off, it took very little pressure to compress the strut and then took over a min to fully extend. Its not the worst strut I have ever seen but its junk. Now to see about getting the lifetime warr covered in the morning...
__________________
2004 X5(E53) 3.0L 1999 M3(E36) 2003 Z4(E85) 3.0L |
|
||||
|
Just checked my overflow tank and the rod wasn't visible but it was full.
Stuck my finger in and the whole damn block holding the rod broke off! ![]() Now 6 days wait for delivery of a new one w/cap... ![]() Will try fishing it out later so I have at least something to drive. Sent from Embassy network using Tapatalk
__________________
"When the Team Chief said.... You're trapped in a hole with nothing but a goat and a slinky, what do you do? Stubby said, I'm not sure but it won't end well for the goat...." ~(Overheard) Last day, Phase 3, Q Course |
![]() |
| Bookmarks |
|
|
|
|