Successfully coded my E70

[Mr.X5_3.0si-retired]

got software all installed, everything updated successfully as mentioned
jumped over to the NCS DIY and followed it to a T
i'm plugged in, key fob is in the slot, following building the profile
get to pressing F1 than select CAS, than F3 for ZCS/FS f. ECU and get an error

VIN is faulty coapi-2000: EDIABAS or SGBD error IFH-0003: DATATRANSMISSION TO INTERFACE DISTURBED

searching google about it now

i did notice when i plugged the cable into the computer i had to manually find the USB drivers for it so i selected the driver from the disc in the USB Drivers folder, ftdiport and it installs as a USB Serial Port (COM3), there is one other driver, ftdibus that i didn't try fully installing.

any suggestions while i'm google searching?

haha i thought i was so close too

*EDIT*
got error IFH-0003: DATATRANSMISSION TO INTERFACE DISTURBED cleared
i had the car sitting to long with the key fob in, turned on the vehicle and my cable LED came back on but now i got another error
VIN is faulty coapi-2001: EDIABAS not initiated even tho i see the EDIABAS Server sitting in the toolbar at the bottom