Nothing.

I have 0 deductible glass. Safelite dropped the ball for a month and after the shop I was dealing with said they ordered the aftermarket version I found the PN for but did not Safelite corporate ordered it from BMW.

i need a new windshield, mine is pitted and developed a crack on the passenger side. I'd be interested in getting the climate windshield. so you ordered it directly from BMW and had a shop install it? how much do they cost?

http://i1359.photobucket.com/albums/...psf98bbe2b.jpg

http://i1359.photobucket.com/albums/...ps9cf894d1.jpg

http://i1359.photobucket.com/albums/...psde0d0fb2.jpg

be careful using the scissor jack :wow: they are pretty flimsy. also remember to torque down the bolts on the spacer as well as the lugs for the wheels. 103 +/- 7 ft/lb

i went with 25mm in the front, turned out pretty good. i think it would look a little better if you went a little low ;)

Ya i hate using that jack but I usually lay the wheel flat under the car by the jack just to make sure ..
Would you have rather go with 20mm up front?

No torque wrench...unfortunately
In 60miles I'll check with one
Do you have to check only the lugs holding the wheel or the spacer?im confused reading the instructions
Or both?

....and after 100 miles remove the wheels & re-torque spacers.

Got my answer!
Thx

20mm require longer bolts...


Sent from my iPhone using Tapatalk

^ yea i would go with the 25mm in the front. they do not require the longer bolts and bolt directly to the hub like your 30mm did.

http://i1359.photobucket.com/albums/...ps41220a14.jpg

http://i1359.photobucket.com/albums/...ps131a58a1.jpg

Looking good buddy, we have the same set up http://img.tapatalk.com/d/14/07/05/va8useve.jpg
http://img.tapatalk.com/d/14/07/05/7ytety6u.jpg


Sent from my iPhone using Tapatalk