does work on a X5 2011?

The only E70 X5 that this applies to is the X5M

You would need more than what is said on here , example : fenders , bumper . Pretty much a full front end convention since the lights only fit e70/71 M & x6


Sent from my iPhone using Tapatalk

got it
thanks a lot

whoops - I emailed them to you before I came here to post. Someone already posted them

can u please email me instruction and part number for retrofit harness to [email protected]
thanks in advance

the instructions are downloadable from the link in post number 119 above. The harness part number is 61122312375

330 ZHP and folks who have done this retrofit, I just purchased a set of these lights on eBay. They are ECE pattern, so will be curious to see how they compare to our DOT pattern (there's been discussion on DOT vs ECE for years)

Anyway, in another thread you mentioned you had two wires coming into the interior that you didn't know what to do with - a black/green, black/blue). Did you end up just taping those back, or did you find where they went?

You also noted the Adaptive Cornering Control (I believe that is when the foglight comes on?) something to do with SA524 which is the option code for Adaptive COrnering...did you get that sorted out?

I have a 2012 X6, which I believe has a FRM 3, so I should be good with not having to replace it.

Chris

I did just tape off the unneeded wires.

I do not know about the differences for the light patterns for the E70 LED headlights specifically. My guess is the defined (__// up to the right light spread???)

For the X6M and X5m there isn't any foglights - so the adaptive movement is within the headlights and is controlled under $524 for the xenon light housings.

Once you add $552 and remove $524 and $522 in the VO the coding is complete.

This is of course after you have properly installed the harness and you have the latest FRM3.

My X5 is a mid 2012 build and I had to replace my FRM with the last version and code it with the VO.

Only then would everything work 100% properly.

Please provide the part number of your FRM3

mine had the 252 part number and I had to swap in the 375 part number

01 Footwell module 3 1 04/2013 61359287252 ENDED 01 Footwell module 3 1 61359308375

btw - the adaptive headlight on the E7x only controls light movement based on load on the vehicle and the direction of the steering input...

It is NOT the later (first avail on 7er) control over the lighting to place oncoming traffic in a "blind spot" of lighting